Showing 1–12 of 152 results
-
TG-DS-Vu-2 to fit Garmin GT34
$99.95This item is user friendly for various installation options – * Trolling Motor * Side of the Jack Plate * Hole Shot Plate or * Set Back Additional components are required.
It is important for us to know this please. This Transducer Shield DOES NOT fit the Garmin GT 36 or GT 56 transducer.NOTE: When the transducer is attached to a Set Back, Hole Shot Plate or the side of a Jack Plate, it will not track the bottom when up on plane because the transducer is out of the water. For bottom reading on plane, a transducer inside the hull will be required.
-
AP-EAG-TRI-SH to fit Lowrance® Eagle Tripleshot Transducer # 000-16285-001 on a Transom
$94.95For transom installation to protect your transducer from side to side and front to back impact. Ideal for boats with flat transoms and for boats without a jack plate. Recommended as an added accessory to our SBB-5 Spring Back Bracket.
It is very important that you complete the questionnaire in full when ordering any of our products.
-
-
TS-EAG-TS fits Lowrance® Transducer Eagle TripleShot HD
$179.00TS-EAG-TS fits Lowrance Eagle TripleShot HD
-
Armor Plate Shim Kit
$49.99Transom Angle not perfectly angled for your transducer and still getting blurry sonar images?
WE’VE GOT YOU COVERED! Our NEW Armor Plate Shims are a small investment that will provide a huge difference in your fish finders performance. These kits come in 3 different angles for 6 or more variations so you can get just the right angle needed just for your vessel.
-
L Bracket Shim Kit
$49.99Say Goodbye to Guesswork! Achieve the Perfect Transducer Angle with Our NEW L-Bracket Shims! These kits come in 3 different angles for 6 or more variations. Don’t let a slightly off-kilter transducer cost you the catch.
-
-
LB-3-LW Blank L. Bracket – for PORT SIDE
$49.95L. Bracket without pre-drilled holes used on T-H Marine Manual and Pro Hi Jacker 6, 8, 10 and 12″ jack plates and Bob’s 4″ or over 12″ Jack Plates.
-
ATLAS 8″ to 12″ Jack Plate – L3 (w/ offset)- PORT or PASSENGER SIDE
$79.95L Bracket with 3 inch offset to attach a Transducer Shield to the side of an Atlas Hydraulic 8″, 10″ or 12″ Jack Plate. Also available for the Port Side. It is very important that you complete the questionnaire when ordering this item.you
-
TM-CMSI-7.1 fits Humminbird® Transducer XM 14 HW CMSI T – Compact MEGA Side Imaging+ Transducer
$179.00TM-CMSI-7.1 fits Humminbird® Transducer XM 14 HW CMSI T
-
LB-SS-6-8-10-12-L to attach a Transducer Shield to Sea Star 6, 8, 10, 12″ jack plate
$59.95L Adaptor Bracket used to install a Transducer Shield to the side of an Sea Star 6″, 8″, 10″ or 12″ Hydraulic Jack Plate
