_{Item # TS-LSS2-L is built in High Quality Aluminum Alloy and Black Powder Coated. It is designed to fit Lowrance® LSS2 (10-1/4”) Structure Scan Transducer. This item DOES NOT fit the Lowrance® LSS1 (6”) Structure Scan transducer. Please go to TS-LSS-1 if you have the shorter transducer.} 

^{NOTE:  When the transducer is attached to a Set Back, Hole Shot Plate or the side of a Jack Plate, it will not track the bottom when up on plane because the transducer is out of the water.  For bottom reading on plane, a transducer inside the hull will be required.}

_{The Sleek Hydrodynamic Design will cut through the water for less drag, reduces collection of debris, keeps the transducer positioned correctly and will not interfere with the transducer signal.}

_{Item TS-LSS2-L along with additional accessories can easily be bolted to the side of a Jack Plate, on the Hole Shot Plate under the Jack Plate, OR on the boat set back. For this installation, please see L Brackets or Wedges. When installing a Structure Scan transducer it is important to be aware that an in hull transducer will also be required. The Structure Scan transducer signal picks up trees and structure etc. A pod or skimmer transducer will pick up fish, depth and will separate the fish from the structure. Resulting in the best performance when the boat is up on plane.}

_{Item TS-LSS2-L is approximately 10-1/2” long and cannot be installed on a trolling motor.  If you were planning on installing an LSS2 transducer on your trolling motor,  then please see Item # TS-LSS2-3D.}

_{It is very important that you complete the questionnaire when ordering this item. The information you provide will help us to assist you better and avoid a delay in shipping your order.}

Proudly Designed and Built in the USA
See More Fish …… Catch More Fish